![]() But I knew this going in, so I don't discount my rating because that is what is was supposed to be. Ok for the field but not great for precision shooting. It is a MilSpec trigger with a hefty 7lb pull. In ten shots I virtually eliminated the center bull and was shooting through the hole on subsequent rounds. ![]() After one adjustment I put every follow up round dead in the bullseye. The first three rounds were touching each other at 50 yards about and inch below the bull. I bore sighted the scope and then took it to the range. The two together was considerably more expensive than others I looked at. I mated it with a 1-4 24mm Trijicon scope. I like the ergonomic inserts on the stock, grip and handle. The action and smooth operation right out of the box impressed me. PISTOL GRIP: Daniel Defense Pistol Grip, Glass Filled Polymer with Soft Touch OvermoldingĪfter looking at many AR style 556 rifles including Ruger, Sig, Savage and others, I settled on the DDM4V7 MilSpec version.BUTTSTOCK: Daniel Defense Buttstock, Glass Filled Polymer with Soft Touch Overmolding.RECEIVER EXTENSION: 6 Position Mil-Spec 7075-T6 Aluminum.CHARGING HANDLE: GRIP-N-RIP Charging Handle, Body CNC Machined of 7075-T6 Aluminum, Handles & Latch CNC Machined of 6061-T6 Aluminum, Heavy Duty Stainless Steel Roll Pins, Type III Hard Coat Anodized.HANDGUARD: Daniel Defense MFR 15.0, CNC Machined of 6061-T6 Aluminum, M-LOK Attachment, Type III Hard Coat Anodized.BOLT CARRIER GROUP: M16 Profile, Mil-Spec MP Tested, Chrome Lined, Properly Staked Gas Key.MUZZLE DEVICE: Daniel Defense Flash Suppressor, 17-4 PH Stainless Steel, Salt Bath Nitride Finished.GAS SYSTEM: Pinned Low Profile Gas Block CNC Machined of 4140 hardened steel and Mil-Spec Heavy Phosphate Coating, Mid-length, Direct Impingement.BARREL: Chrome Moly Vanadium Steel, Cold Hammer Forged, 1:7 Twist, 16" Government Profile, Mid-length Gas System, Chrome Lined, Mil-Spec Heavy Phosphate Coated, and HP/MPI Tested.CNC Machined of 7075-T6 Aluminum, Type III Hard Coat Anodized UPPER RECEIVER: Mil-Spec with Indexing Marks and M4 Feed Ramps.LOWER RECEIVER: Mil-Spec with Enhanced Flared Magazine Well and Rear Receiver QD Swivel Attachment Point.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |